公路防撞墻模具一般都是采用現澆筑的方式來操作的，都是經過固定，然后把混凝

土灌入到模具當中的。公路防撞墻模具一般在高速公路上使用的，我們經常會見到

高速公路上有各種防撞墻，這些都是采用公路防撞墻模具拼接而成的，符合一定的

使用標準，采用圓弧的設計，平時使用的包括4米或者是2米的都有，中間是帶孔的

，帶有反轉邊，便于灌裝，生產效率高，降低了各種使用的問題。

公路防撞墻模板制作的公路防撞墻混凝土構件主要是在高速公路的兩側或者是中間

的位置進行使用的，在生產的過程中，需要注意的是要保證模具的拼接嚴密，鋼模

具它自身是有著很強的硬度，為了方便他的拆模，就需要將模具設計可拆卸的形態

才可以，這樣也就要求工人在生產之前，一定要進行檢查模具，看一下有沒有拼接

遺漏的問題出現。

The mold of highway anti-collision wall is generally operated by cast-

in-situ, which is fixed and then poured into the mold. Highway anti-

collision wall molds are generally used on expressways. We often see

various anti-collision walls on expressways. These walls are spliced by

highway anti-collision wall molds, which meet certain use standards and

adopt circular arc design. They are usually used, including 4m or 2m,

with holes in the middle and reverse edges, which is convenient for

filling and high production efficiency, It reduces various use problems.

The concrete components of highway anti-collision wall made by highway

anti-collision wall formwork are mainly used on both sides or in the

middle of the highway. In the process of production, it should be noted

that the mold should be tightly spliced. The steel mold itself has strong

hardness. In order to facilitate its removal, the mold needs to be

designed in a detachable form, This requires workers to check the mold

before production to see if there is any problem of missing splicing.